Table of Contents
Advertisement
Spurious emissions
The Spurious Emissions measurement is to identify or determine the power level of in-
band or out-of-band spurious emissions within the necessary channel bandwidth and
modulated signal. The SPA06MA-O indicates either Pass or Fail based on the
specified limit of the signal.
Setting measure setup
After configuring the spectrum measurement in
on page
frequency setting is not used in the Spurious Emissions mode.
To set measure setup
1
Tap the Setup (
2
Tap Configuration or the Configuration(
3
Tap Range under the chart screen and switch to On to display or Off to hide the
selected range in the result table.
You can select the range number between 1 and 20 to add as a new or change
the existing settings.
4
Tap Start Frequency/Stop Frequency and enter the value for the selected range
using the on-screen keyboard.
5
Tap Start Limit/Stop Limit and enter the lower limit/upper limit for Pass/Fail indi-
cation.
6
Tap Attenuation/RBW/VBW and specify or select the value.
7
Tap Measurement Type between Full and Examine.
The Examine mode displays only the selected range while the Full mode lets the
instrument automatically change the selected range from one another.
8
Tap Average on the box of upper screen and enter the value between 1 and 100
to set the number of measurements to be averaged.
You can also access this menu through Menu > Average on the side bar.
To set limit
1
Tap Menu > Limit.
2
Tap to switch the Test Limits to On or Off to enable or disable Pass/Fail indica-
tion.
3
Optional: Tap the Save hot key on the side bar and select the save option from the
choices available for your measurement.
Figure 44
April 2021
9, you can set the measure setup to continue your measurement. The
) icon in the side bar.
shows an example of LTE/LTE-A FDD spurious emissions measurement.
SPA06MA-O User's Guide
"Configuring spectrum measurements"
) icon.
22145360, R005
Chapter 5 Using LTE/LTE-A FDD Analyzer
Conducting RF measurement
Page 93
Advertisement
Table of Contents
