Table of Contents
Advertisement
4
The message disappears and the red line for the current antenna direction moves
to the 0° line and overlaps to let you know that the initialization is done success-
fully.
5
Hold the antenna handle set horizontally and make the measurement.
6
The message disappears and the red line for the current antenna direction moves
to the 0° line and overlaps to let you know that the initialization is done success-
fully.
7
Obtain a Persistent RSSI value:
a
b
8
To continuously obtain Persistent RSSI values:
a
b
c
April 2021
NOTE
The AntennaAdvisor Handle has a built-in low-noise amplifier (LNA) and you
can turn it on and off by toggling the physical On/Off switch located on the rear
side of the handle unit
Press the Trigger button located on the antenna handle.
Each time you press the physical button on the handle, a beep sounds and a
power level of the received signal is plotted as a blue dot on the radar chart.
Depending on the strength of the measured value, you may hear different
tones of beeping.
While panning the antenna horizontally to vary the angle of the direction,
repeat pressing the TRIGGER button to obtain at least five points if you want
to do the localization.
Press and hold the TRIGGER button located on the antenna handle to start a
continuous measurement.
Pan the antenna handle horizontally through the angle of 360 degrees you
desire. A beep is sounded repeatedly to let you know that the measurement
is continuing and measured values are plotted on the radar chart.
Release the TRIGGER button to stop the continuous measurement.
SPA06MA-O User's Guide
22145360, R005
Chapter 3 Using Interference Analyzer
Conducting interference measurements
Page 53
Advertisement
Table of Contents
