Table of Contents
Advertisement
Setup and load the file onto the instrument using the Save/Load icons on the side bar.
To set measure setup
1
2
3
4
5
6
7
8
To set limit
1
2
3
Figure 74
April 2021
Tap the Setup (
) icon in the side bar.
Tap Configuration or the Configuration(
Tap Range under the chart screen and switch to On to display or Off to hide the
selected range in the result table.
You can select the range number between 1 and 20 to add as a new or change
the existing settings.
Tap Start Frequency/Stop Frequency and enter the value for the selected range
using the on-screen keyboard.
Tap Start Limit/Stop Limit and enter the lower limit/upper limit for Pass/Fail indi-
cation.
Tap Attenuation/RBW/VBW and specify or select the value.
Tap Measurement Type between Full and Examine.
The Examine mode displays only the selected range while the Full mode lets the
instrument automatically change the selected range from one another.
Tap Average on the box of upper screen and enter the value between 1 and 100
to set the number of measurements to be averaged.
You can also access this menu through Menu > Average on the side bar.
Tap Menu > Limit.
Tap to switch the Test Limits to On or Off to enable or disable Pass/Fail indica-
tion.
The result table color for Pass is green, and the result table color for Fail is red.
Optional: Tap the Save hot key on the side bar and select the save option from the
choices available for your measurement mode.
shows an example of LTE/LTE-A TDD spurious emissions measurement.
SPA06MA-O User's Guide
22145360, R005
Chapter 6 Using LTE/LTE-A TDD Analyzer
Conducting RF measurement
) icon.
Page 145
Advertisement
Table of Contents
