Table of Contents
Advertisement
measurements displayed on the quick access and display tab. See
spectrum measurements" on page 9
route map are available in the screen with two categories: general setting and carrier
setting. For Map Configuration, you need to tap Menu icon on the side bar.
1
If required, connect a GNSS receiver to your instrument for outdoor mapping.
Indoor mapping does not necessarily need a GNSS antenna.
2
Tap the Setup (
3
Tap to switch the Plot Point to GPS, Position, or Time.
a
–
–
b
4
Tap to switch Plot Item to RSRP, RSRQ, SINR or SNR.
5
Tap Configuration to continue with carrier setting or general setting.
General setting
1
Tap General Setting on the screen.
2
To set the reference level, tap the number under NR or LTE and input the refer-
ence level using the on-screen keyboard.
3
Tap to switch the Sweep Speed between Fast and Normal.
–
–
4
Tap Trigger to set Internal, External or GPS as required.
–
–
–
April 2021
) icon on the side bar.
To collect data/plot points automatically as you move around in a vehicle or
outside, select GPS, then tap to switch the Screen Mode between Map and
Full.
With the Map setting, you can view only the collected points that can be seen
within the boundary of the loaded map.
With the Full setting, you can view all the collected points of the route without
the loaded map.
To collect data/plot points manually in an indoor layout without a GPS
antenna, select Position (If you tap the Start button on the right panel of the
map, the Undo icon appears).
Fast: measuring PCI, RSRP, RSRQ, P-SS SNR, S-SS SINR, S-SS RSSI, P-
SS Power, S-SS Power for one signal with the strongest RSRP for LTE
carrier/ measuring PCI, SSB Index, S-SS RSRP, P-SS RSRP, P-SS SNR, S-
SS SINR, S-SS RSRQ for one signal with the strongest S-SS RSRP for NR
carrier
Normal: measuring PCI, RSRP, RSRQ, P-SS SNR, S-SS SINR, S-SS RSSI,
P-SS Power, S-SS Power for six signal with top-down order based on the
strongest RSRP signal for LTE carrier/ measuring PCI, SSB Index, S-SS
RSRP, P-SS RSRP, P-SS SNR, S-SS SINR, S-SS RSRQ for eight signals
with top-down order based on the strongest S-SS RSRP signal for NR carrier
Internal: when starting a signal processing using the internal reference clock
and creating a trigger
External: when starting a signal processing based on the external input
trigger
GPS: When synchronizing the signal processing via the GPS receiver. If you
want to check the time error correctly, set the trigger to GPS
SPA06MA-O User's Guide
for more information. The setup menus for NSA
22145360, R005
Chapter 8 Using NSA Signal Analyzer
Conducting OTA measurements
"Configuring
Page 281
Advertisement
Table of Contents
