Table of Contents
Advertisement
System Recovery
C A U T I O N
Notes on executing the factory recovery function
Proced ure to execute the factory recovery
Network Analyzer
By executing system recovery, you can return the E5080A's
system (the Windows operating system and the firmware) to the
factory state (at the time of purchase
Strictly follow the steps described below. If you do any
operation other than the following steps, the system may
not be recovered.
Executing the factory recovery function causes the following
conditions:
• In addition to the Windows operating system and the firmware,
the following settings of the E5080A are returned to the factory
state.
•
•
•
• The driver for the supported printer which is installed after
purchase is deleted.
• You need to execute initial registration again.
Files that you have created using the save function (files in the D
drive) are not affected. However, Keysight recommends backing
them up before executing system recovery for precautionary
purposes. For more information on backup, refer to "Backing Up
the Data" as described in E5080A Online Help.
This section describes how to return the contents of the C drive to
the factory state.
You need a keyboard for this operation.
N O T E
* 1. The default setting of the hard disk is recovered during the system recovery.
For the hard disk that had failed earlier and had been replaced (after
purchase), its default setting may not be the same as the factory state.
Network setting
GPIB setting
Printer setting
Troubleshooting
*1
).
2
23
Advertisement
Table of Contents
