Command Reference - Keysight 53147A Operating And Programming Manual

Command Reference

This section describes the SCPI Subsystem commands and the IEEE 488.2
Common Commands for the Keysight 53147A, 53148A, and 53149A. The
information in this section is intended to help you program the instrument over its
GPIB or RS-232 serial interface.
The commands are presented in alphabetical order.
– SCPI Subsystem commands are described on pages 208
– IEEE 488.2 Common command descriptions start on page 253.
– A description of the Group Execute Trigger command is also included on
For each command description:
– Where the phrase "Sets or queries" is used, the command setting can be
– For example,
– Unless otherwise noted, a command described as an event cannot be queried.
– Unless otherwise noted, the command setting is affected by *SAV/*RCL.
– The square brackets, [ ], are used to indicate that the element(s) within the
– The vertical bar, |, is used to mean "OR" and is used to separate alternative
– The short form of keywords is shown in uppercase.
– Quotation marks may be part of the command's parameter;
– Unless otherwise noted, a command is sequential (not overlapped).
Keysight 53147A/148A/149A Operating and Programming Guide
through 251.
page 216.
queried by omitting the parameter and appending a "?" to the last command
keyword.
:ROSC:SOUR INT | EXT
can be queried with
:ROSC:SOUR?
brackets are optional. Note, the brackets are not part
of the command and should not be sent to the instrument.
options.
the quotation marks shown must be sent to the instrument.
Programming 3
207