Table of Contents
Advertisement
Item
Trust Type
Max Connection
Connection
Control
Connection Idle
Timeout
Alive Check
Timeout
Enable
Edit
Save
Undo
5.1.2.6
Specify Remote UDP
Item
Remote
Host
Remote
Port
Serial Port
Definition
Enable
196 of 359
© NetComm Wireless 2019
Notes
n/a
n/a
n/a
n/a
n/a
n/a
Button
Button
Button
Table 133 – Operation Mode Definition for each Serial Port – UDP Mode
Figure 228 – Legal Host IP Definition - UDP operation mode
Notes
Mandatory field.
Select from the two options in the drop down list:
Default setting: 4001
Indicate the UDP port of peer UDP hosts.
Value Range: 1 - 65535
SPort-0Default setting:
Apply the UDP hosts for a selected serial port.
Up to four (4) UDP servers can be configured at the same time
for each serial port.
Check Enable to enable the access to this host.
Disabled by default.
Description
Field is disabled – it is not relevant to the UDP
operation mode.
Field is disabled – it is not relevant to the UDP
operation mode.
Field is disabled – it is not relevant to the UDP
operation mode.
Field is disabled – it is not relevant to the UDP
operation mode.
Field is disabled – it is not relevant to the UDP
operation mode.
Field is disabled – it is not relevant to the UDP
operation mode.
Click Edit to add or change an Operation Mode
definition.
Click Save to save the settings
Click Undo to cancel the settings
Description
Specific IP address –Enter the IP address of the trusted
host.
IP Range – Enter the beginning and end IP addresses of the
range of trusted TCP clients.
User Guide
Advertisement
Table of Contents
