Create/Edit L2Tp Client - NetComm NTC-400 Series User Manual

Item
Save Button
When Client is selected the L2TP Client Configuration and the L2TP Client List & Status sections display below the
Configuration window.
Item
L2TP Client Checkbox
Save Button
When L2TP Client is enabled the Add, Delete and Refresh buttons on the L2TP Client List & Status become active.
6.1.3.9

Create/Edit L2TP Client

Click on the Add button to create a new client in the list. You can create up to eight L2TP clients.
Item
Add Button
Delete Button
Refresh Button
Client details Fields in row.
NTC-400 Series
Notes
Click Save to create the user account.
Table 158 – L2TP Client Configuration
Figure 264 – L2TP Client List & Status
Notes
Click  Enable to activate the L2TG client functionality
Click Save to create the user account.
Table 159 – L2TP Client List & Status
Figure 265 – L2TP Client List & Status
Notes
Click the Add button in the User Account List to open the User Account
Configuration screen where you can create new user accounts, see next
section.
Up to eight (8) client accounts can be created.
Click  Select on one or more Client descriptions and then click the Delete
button to permanently remove them from the list.
Click the Refresh button to test the connection.
The following details are displayed for each client: ID number, Tunnel
Name, Interface, Virtual OP address, Remote IP/FQDN address, Remote
Subnet address, connection Status, and Enable/Disabled status.
These are all set in the L2TP Client Configuration window. See the next
section for details regarding these settings.
Description
Description
Description
© NetComm Wireless 2019
229 of 359