Create / Edit Remote Host - NetComm NTC-400 Series User Manual

Item
GNSS Message No default setting.
Types
SBAS Disabled by default.
Assisted GPS Enabled by default.
Data to Disabled by default.
Storage
Save Button
8.3.1.2

Create / Edit Remote Host

Remote Host rules allows you to create custom rules for sending NMEA data (National Marine Electronics Association data
has a standard data format supported by all GPS manufacturers) to specific IP addresses and Ports.
The router supports ten Remote Host rule sets.
Click the Add button is applied to open the Remote Host Configuration screen.
NTC-400 Series
Notes
Select one or more GNSS Message Types to use for transmitting or recording
GPS data.
Only select the type you need, otherwise it will consume unnecessary
network bandwidth.
Check  Enable to activate satellite-based augmentation system (SBAS).
Check  Enable to activate Assisted GPS (A-GPS).
Select the duration for downloading the Differential Almanac Corrections
data from A-GPS server through IP network.
Note – Some devices may not support this function.
Check  Enable to activate GNSS data to storage functions.
Select Internal or External Device to store log data to from the drop-down list
(required setting).
Specify the time interval between two continuous data log refreshes.
- Five (5) seconds is the default setting.
- Value Range: 5 - 60 seconds.
Data Format (required setting): RAW, or GPX
Data file name (required setting) Define the file naming convention.
Split file
Check  Enable to activate GNSS data file splitting functions.
- Enter the Size in KB or MB (select from drop down list)
Download log file
Select a log file from the drop down list and click the Download log file
button to download through the Web GUI.
If the log format specified to download is .gpx, the standard GPX format is
used.
Click the Save button to save the configuration
Table 251 – Enable Location Tracking
Figure 396 – Remote Host List
Description
© NetComm Wireless 2019
337 of 359