NetComm NTC-400 Series User Manual page 175

Configuration Path
IPSec
Configuration Path
Tunnel
Tunnel Name
Interface
Tunnel Scenario
Operation Mode
Configuration Path
Local Subnet
Local Netmask
Full Tunnel
Remote Subnet
Remote Netmask
Remote Gateway
Configuration Path
Key Management
Local ID
Remote ID
Configuration Path
Negotiation Mode
X-Auth
For Network-B at Branch Office
Following tables list the parameter configuration as an example for the "My Certificate" function used in the user
authentication of IPSec VPN tunnel establishing, as shown in above diagram. The configuration example must be combined
with the ones in following two sections to complete the whole user scenario.
Use default value for those parameters that are not mentioned in the tables.
NTC-400 Series
[IPSec]-[Configuration]
■ Enable
[IPSec]-[Tunnel Configuration]
■ Enable
s2s-101
WAN 1
Site to Site
Always on
[IPSec]-[Local & Remote Configuration]
10.0.76.0
255.255.255.0
Disable
10.0.75.0
255.255.255.0
118.18.81.33
[IPSec]-[Authentication]
IKE+X.509 Local Certificate: HQCRT Remote Certificate: BranchCRT
User Name Network-A
User Name Network-B
Main Mode
None
[IPSec]-[IKE Phase]
175 of 359
© NetComm Wireless 2019