Specify Remote Tcp Server - NetComm NTC-400 Series User Manual

Hide thumbs Also See for NTC-400 Series:
Table of Contents

Advertisement

Item
Connection
Idle Timeout
Alive Check
Timeout
Enable
Save
Undo
5.1.2.2

Specify Remote TCP Server

When TCP Client is selected as the Virtual COM Operation Mode the Legal Host OIP/FQDN Definition (for TCP Client
operation mode) is displayed in a separate section on the Virtual COM tabbed page.
Press the Edit button to activate the fields for entering details of a new server or to edit the details of an existing one.
Item
To Remote Host
Remote Port
Serial Port
Definition Enable
192 of 359
© NetComm Wireless 2019
Notes
Default setting: 0
The TCP connection is disconnected when the idle time has
elapsed.
Value Range: 0 - 60
minutes
Enter the idle timeout period in minutes.
Default setting: 0
The TCP connection is terminated if it does not receive a
response from an alive-check before this time period has
Value Range: 0 - 60
elapsed.
minutes
Enter the time period of alive check timeout in minutes.
Check  Enable to activate the corresponding serial port in
Disabled by default.
specified operation mode.
Button
Click the Save button to save the configuration
Button
Click Undo to cancel the changes to settings.
Table 129 – Operation Mode Definition for each Serial Port – TCP Client
Figure 224 – Operation Mode Definition for each Serial Port – TCP Client
Notes
Mandatory setting.
Mandatory setting.
Default setting: 4001
Value Range: 1 - 65535
Default setting: SPort-0 Apply the TCP server connection for a selected serial
Disabled by default
Description
On-Demand – Initiates TCP connection only when required
to transmit and disconnect at idle timeout.
Note – Idle timeout is only available when On-
Demand is selected in the Connection Control field,
see above.
Description
Press Edit button to enter IP address or FQDN of the
remote TCP server for transmission of serial data.
Enter the TCP port number.
This is the listening port of the remote TCP server.
port.
Up to four (4) TCP servers can be configured at the
same time for each serial port.
Check  Enable to enable the TCP server configuration.
User Guide

Advertisement

Table of Contents
loading

Table of Contents