Configure Wi-Fi Setting; Ap Router Mode - NetComm NTC-400 Series User Manual

Item Notes
WPS N/A
3.3.1.8

Configure Wi-Fi Setting

Item Notes
Wi-Fi Module Enabled by
default.
Wi-Fi Operation
Mode
3.3.1.9

AP Router Mode

In AP Router mode, the device not only supports the connection of other stations but also the router function. The WAN port
and the NAT function are enabled.
Item Notes
Green AP Disabled by
default.
VAP Isolation Enabled by
default.
NTC-400 Series
Pressing the 2.4G or 5G button directs you to the Wi-Fi Protected Setup page.
Table 63 – Wi-Fi Configuration Setting - Basic Configuration
Figure 113 – Wi-Fi Configuration Setting - 2.4G/5G Wi-Fi Configuration
Check the Enable box to activate the Wi-Fi function.
Specify the Wi-Fi Operation Mode according to your application.
Refer to the following table for AP Router Mode, WDS Only Mode, WDS Hybrid Mode,
Universal Repeater Mode, AP Only Mode, and Client Mode settings.
Table 64 – Wi-Fi Configuration Setting - 2.4G/5G Wi-Fi Configuration
Figure 114 – AP Router Mode
Check the Enable box to activate the Green AP function. Green AP attempts to optimise
wireless throughput and power consumption.
Check the Enable box to activate this function.
Description
Description
Description
95 of 359
© NetComm Wireless 2019