3.3.1.11 Wds Hybrid Mode - NetComm NTC-400 Series User Manual

Item
Encryption Mandatory field.
Default setting: None
Scan Remote AP's N/A
MAC List
Remote AP MAC 1 - Mandatory field.
4
Save Button
Undo Button
Apply Button

3.3.1.11 WDS Hybrid Mode

In WDS Hybrid mode, the device bridges all the wired LAN and WLAN clients to other WDS or WDS hybrid enabled Wi-Fi
devices which the device is associated with.
NTC-400 Series
Notes
RADIUS Server Port (The default value is 1812)
RADIUS Shared Key
When WPA-PSK is selected, the authentication uses pre-shared key instead of
RADIUS server.
When WPA2-PSK is selected, the authentication uses pre-shared key instead of
RADIUS server.
Select the desired encryption method and enter the required key(s). The available
method in the dropdown list depends on the Authentication you selected.
None – the device is open with no encryption.
WEP - Up to 4 WEP keys can be set and you have to select one as current key. The
key type can set to HEX or ASCII. If HEX is selected, the key should consist of (0 to 9)
and (A to F).
If ASCII is selected, the key should consist of ASCII table.
TKIP - TKIP was proposed instead of WEP without upgrading hardware. Enter a Pre-
shared Key for it. The length of the key is from 8 to 63 characters.
AES - The newest encryption system in Wi-Fi. This is also designed for the fast
802.11n high bitrates schemes. Enter a Pre-Shared Key. The length of the key is from
8 to 63 characters.
We recommend that you use AES encryption for security as it is the most secure.
TKIP / AES - TKIP / AES mixed mode. Client stations can associate with this device via
TKIP or AES. Enter a Pre-Shared Key. The length of the key is from 8 to 63 characters.
Press the Scan button to scan the spatial AP information, and then select one from
the AP list. The MAC of the selected AP will be automatically entered in the following
Remote AP MAC table.
Enter the remote AP's MAC manually or via auto-scan. The device will bridge the
traffic to the remote AP when associated successfully.
Click the Save button to save the current configuration.
Click the Undo button to restore configuration to previous setting before saving.
Click the Apply button to apply the saved configuration.
Table 66 – WDS Only Mode
Description
© NetComm Wireless 2019
99 of 359