NetComm NTC-400 Series User Manual page 237

Item
Tunnel Name Mandatory field.
1 - 32 characters
Interface Mandatory field.
Operation Mandatory field.
mode
Remote Mandatory field.
IP/FQDN
Format can be ipv4
address or FQDN
User Name Mandatory field.
Password Mandatory field.
Default Mandatory field.
Gateway /
Remote
Subnet
Authentication Mandatory field.
Protocol
All unselected by
default.
NTC-400 Series
Notes
Add a meaningful name.
WAN-1 is available only when WAN-1 interface is enabled).
The same applies to other WAN interfaces (i.e. WAN-2).
There are three available operation modes: Always on, Failover, Load
Balance
Failover/ Always on: Define whether the PPTP client is a failover tunnel
function or an always on tunnel.
Note – If this PPTP is a failover tunnelling, you will need to select
a primary IPSec tunnel from which to failover to.
Load Balance – Define whether the PPTP tunnel connection will take part
in load balance function of the gateway. You will not need to select which
WAN interface as the system will automatically utilize the available WAN
interfaces to balance traffic loads. For more details on WAN Load Balance,
refer to Basic Network > WAN & Uplink > Load Balance tab.
Note – Load Balance function is not available for the gateway
with single WAN.
Enter the public IP address or the FQDN of the PPTP server.
Enter the User Name for this PPTP tunnel to be authenticated with when
connecting to PPTP server.
Value Range: 1 - 32 characters
Enter a secure password for this PPTP tunnel to be authenticated with
when connecting to PPTP server.
Specify a gateway for this PPTP tunnel to reach PPTP server.
When you choose Remote Subnet, you need to specify one more setting:
the remote subnet. It is for the Intranet of PPTP VPN server. So, at PPTP
client peer, the packets whose destination is in the dedicated subnet will
be transferred via the PPTP VPN tunnel. Others will be transferred based
on current routing policy of the security gateway at PPTP client peer.
If you choose Default Gateway option for the PPTP client peer, all packets,
including the Internet accessing of PPTP Client peer, will go through the
established PPTP VPN tunnel. That means the remote PPTP VPN server
controls the flowing of any packets from the PPTP client peer. Certainly,
those packets come through the PPTP VPN tunnel.
The Remote Subnet format must be IP address/netmask (e.g. 10.0.0.2/24)
Specify one or more Authentication Protocol(s) for this PPTP tunnel.
Available authentication methods are: PAP, CHAP, MS‐CHAP or MS‐CHAP
v2
Description
© NetComm Wireless 2019
237 of 359