Create/Edit Multiple Communities - NetComm NTC-400 Series User Manual

Item
Remote Access IP String format: any Ipv4
SNMP Port
Save
Undo
7.1.3.4

Create/Edit Multiple Communities

The SNMP allows you to custom your access control for version 1 and version 2 user.
The router supports up to a maximum of 10 community sets.
When Add button is applied, Multiple Community Rule Configuration page will display:
The following settings are available to configure Multiple Community Rules:
NTC-400 Series
Notes
 v2c box enabled by
It means you can access SNMP by version 1. When Check
default the v2c box.
It means you can access SNMP by version 2c. When Check
the v3 box.
It means you can access SNMP by version 3.
Specify the Remote Access IP for WAN.
address
If you filled in a certain IP address. It means only this IP
It is an optional item. address can access SNMP from WAN side.
If you left it as blank, it means any IP address can access
SNMP from WAN side.
Mandatory field Specify the SNMP Port.
String format: any port You can fill in any port number. But you must ensure the
number port number is not to be used.
Default SNMP port: 161 Value Range: 1 - 65535.
Button Click Save to save the settings.
Button Click Undo to cancel the settings.
Table 192 – Enable SNMP
Figure 316 – Multiple Community List
Figure 317 – Multiple Community Rule Configuration
Description
© NetComm Wireless 2019
281 of 359