Event Handling - NetComm NTC-400 Series User Manual

Item
Scan Approach
Save
When Manually is selected in the Scan Approach configuration setting, press the Scan button to scan for a list of the nearest
available access point. The scan may last for 1 to 3 minutes and the base stations will be added to the Network Provider List
as they are identified.
Item
Provider Name
Mobile System
Network Status
Select
Scan
Apply
Click again on the "Apply" button to drive system to connect to that mobile operator system for the dedicated 3G/4G
interface.
8.2

Event Handling

Event handling allows an administrator to set up pre-defined event profiles of scenarios or incidents for which a standard
response can be defined and pre-assigned. The response can be an action or a message.
NTC-400 Series
Notes
2G Only, 3G Only or 4G Only – If an 'only' option is selected,
network will be register for your chosen option only.
Default setting: When Auto is selected, the cellular module registers
Auto automatically.
If the Manually option is selected, a Network Provider List
screen appears, see next section for details.
Press the Scan button to scan for the nearest access point..
Select the preferred base stations then click Apply button to
apply settings.
Button Click Save to save the settings
Table 233 – USSD Request
Figure 375 – Network Provider List
Notes
Name of provider
3G/4G The system displays the SIM card (identified with SIM_A or
SIM_B) associated with the selected cellular service.
System generated Current – the currently selected network
Forbidden – a detected network but one which is not
available to connect to.
 Select the preferred network then click Apply button to
button
apply settings.
button Click the Scan button to scan for the nearest network.
button Click the Apply button to apply settings.
Table 234 – Network Provider List
Description
Description
© NetComm Wireless 2019
323 of 359