Table of Contents
Advertisement
Item
Synchronization
method
Time Zone
Auto-
synchronization
Time Server
Daylight Saving Time This is an optional item.
Synchronize
Immediately
Sync Result
Save
7.2.3.2
Manual method
When the Manual Synchronization method is chosen the following configuration settings are available:
292 of 359
© NetComm Wireless 2019
Notes
Time Server
This item is Optional field.
GMT+00:00 is the default
setting.
Checked by default.
Auto is the default setting.
Disabled by default.
Button
System generated and
button
Button
Table 203 – System Time Configuration - Time Server Synchronization
Figure 332 – System Time Configuration - Manual Synchronization
Description
This setting determines the configuration settings
available.
Select a time zone, normally where the router is
located, from the drop down list.
Check the Enable button to activate the time
auto-synchronization function with a NTP server.
You can enter the IP or FQDN for the NTP server you
will use, or leave it as auto mode so that the
available server will be used for time
synchronization one by one.
Check the Enable button to activate the daylight
saving function.
When you enable this function, you have to specify
the start date and end date for daylight saving time
in your region.
Based on your selection of time zone and time
server above , when you click the Active button the
system will communicate with time server by NTP
Protocol to get system date and time.
When the Active button is clicked, the Time
Synchronization Results pane will display first the
progress of the synchronisation and then the server
and time of sync.
Click the Close button to hide the results details.
Click the Save button to save the settings.
User Guide
Advertisement
Table of Contents
