Table of Contents
Advertisement
VLAN Tagging
Sometimes ISPs require a VLAN tag to be inserted into the WAN packets from the router for specific services. To enable these
services, enable VLAN tagging and specify the tag on the WAN physical interface. Note that only Ethernet and ADSL physical
interfaces support the feature.
3.1.1.1
Configuring a physical interface
Click on the Edit button for the WAN interface that you wish to configure.
The Interface Configuration screen appears.
Item
Physical
Mandatory field. WAN-1 is
Interface
the primary interface is
factory set to Always On.
Operation
Mandatory field.
Mode
VLAN Tagging Optional setting.
3.1.2
Internet Setup
After specifying the physical interface for each WAN connection, you must configure at least one connection profile to satisfy
the connection process of the SIP/mobile carrier, so that all client hosts on the Intranet of the router can access the Internet.
On the "Internet Setup" page, there are three configuration windows: "Internet Connection List", "Internet Connection
48 of 359
© NetComm Wireless 2019
Figure 51 – Physical Interface List
Figure 52 – Interface Configuration
Notes
Select an interface from the available interface dropdown list.
Select Always on to make this WAN always active. Select Disable to
disable this WAN interface. Select Failover to make this WAN a
Failover WAN when the primary or the secondary WAN link fails,
then select the primary or the existing secondary WAN interface to
switch Failover from.
Note – For WAN-1 the only available option is: Always on
Check Enable to enter tag values provided by your ISP. Otherwise
uncheck the box.
Value Range: 1 - 4096.
Note – This feature is NOT available for 3G/4G WAN connection.
Table 35 – Interface Configuration screen
Description
User Guide
Advertisement
Table of Contents
