Authentication - NetComm NTC-400 Series User Manual

Item
Operation Mode Mandatory field.
Default setting: Always on
Encapsulation Mandatory field.
Protocol
Default setting: ESP
Item
Local Subnet List Mandatory field.
Local Netmask Mandatory field.
6.1.1.5

Authentication

NTC-400 Series
Notes
Set the operation mode for the IPSec Tunnel: Always On, Failover or
Load Balance
If this tunnel is set as a failover tunnel, you need to further select a
primary tunnel from which to failover to.
Note – Failover mode is not available for the router with
single WAN.
Select the Encapsulation Protocol from the dropdown list for this
IPSec tunnel.
Available encapsulations are: ESP or AH
Table 138 – IPSec Tunnel Configuration
Figure 238 – Local & Remote Configuration
Notes
Specify the Local Subnet IP address and Subnet Mask.
Click the Add or Delete button to add or delete a Local Subnet.
Note 1: When Dynamic VPN option in Tunnel Scenario is selected,
there will be only one subnet available.
Note 2: When Host‐to‐Site or Host‐to‐Host option in Tunnel
Scenario is selected, Local Subnet will not be available.
Note 3: When Hub and Spoke option in Hub and Spoke is selected,
there will be only one subnet available
Enter the subnet mask of the local subnet.
Table 139 – IPSec Local & Remote Configuration
Figure 239 – IPSec Authentication
Description
Description
© NetComm Wireless 2019
205 of 359