Table of Contents
Advertisement
Item
Authentication
Protocol
MPPE Encryption
Save
Undo
6.1.4.2
PPTP Server Status list
After the PPTP server has been set up PPTP clients connected to it will be listed in the PPTP Server Status list:
The following details of each connected PPTP client are listed: User Name, Remote IP, Remote Virtual IP, Remote Call ID and
current Actions
Click the Refresh button to renew the PPTP client information.
To create a new client, select Client from the Client/Server drop down list on the Configuration section and then check
Enable in the PPTP Client Configuration section.
When Enable is selected, the buttons on the PPTP Client List & Status section become active.
Click on the Add button to create a new client in the list. You can create up to ten (10) PPTP client user accounts.
NTC-400 Series
Notes
Mandatory field.
Select single or multiple Authentication Protocols for the PPTP server
with which to authenticate PPTP clients.
Disabled by
default.
Available authentication protocols include: PAP, CHAP, MS‐CHAP or
MS‐CHAP v2
Specify whether to support MPPE Protocol. Click Enable to enable
Mandatory field.
MPPE and select 40 bits, 56 bits or 128 bits from dropdown box.
Disabled by
default.
Button
Click Save to save the settings.
Button
Click Undo to cancel the changes.
Table 163 – PPTP Server Configuration
Figure 270 – PPTP Server Status
Figure 271 – PPTP Client Configuration
Figure 272 – PPTP Client List & Status
Description
Note - when MPPE Encryption is enabled, the Authentication
Protocol PAP / CHAP options will not be available.
235 of 359
© NetComm Wireless 2019
Advertisement
Table of Contents
