NetComm NTC-400 Series User Manual page 27

Item
Wi-Fi Enable
Op. Mode
SSID
Channel
Wi-Fi System
Auth. & Security
MAC Address
Action
Wi-Fi Uplink Status
The Wi-Fi Uplink Status shows all information of connected Wi-Fi uplink network.
Item
SSID
BSSID
Channel
Security
RSSI0, RSSI1
Rate
Action
Wi-Fi IDS Status
The Wi-Fi Traffic Statistic shows all the received and transmitted packets on Wi-Fi network.
NTC-400 Series
Value setting
System data. Displays whether the VAP wireless signal is enabled or disabled.
System data. The Wi-Fi Operation Mode of VAP. Depends of device model,
modes are AP Router, WDS Only and WDS Hybrid, Universal
Repeater and Client.
System data. Displays the network ID of VAP.
System data. Displays the wireless channel used.
System data. The Wi-Fi System of VAP.
System data. Displays the authentication and encryption type used.
System data. Displays MAC Address of VAP.
Button Click the Edit button to make a quick access to the Wi-Fi
configuration page. (Basic Network > Wi-Fi > Configuration
tab)
The QR Code button allow you to generate QR code for quick
connect to the VAP by scanning the QR code.
Table 10 – Wi-Fi Virtual AP List
Figure 18 – Wi-Fi Uplink Status
Value setting
System data. Displays the network ID of VAP.
System data. Displays the BSSID for the connected wireless network.
System data. Displays the wireless channel used.
System data. Displays the authentication and encryption setting for the Wi-
Fi uplink connection.
System data. Displays the Rx sensitivity on each radio path..
System data. Displays the link rate for the Wi-Fi uplink connection.
Button Click the Edit button to make a quick access to the Wi-Fi
uplink configuration page. (Basic Network > WAN & Uplink >
Internet Setup tab)
Table 11 – Wi-Fi Uplink Status
Description
Description
© NetComm Wireless 2019
27 of 359