Table of Contents
Advertisement
6.2.1.2
Packet Filter Settings
To enable the Packet Filter functionality:
1
Select Firewall from the Security submenu on the left and then open the Packet Filters tab.
2
Go to the Configuration section of the Packet Filters page:
Click Packet Filters Enable and set the following parameters:
3
Item
Packet Filters
Black List /
White List
Log Alert
Save
Undo
6.2.1.3
Create/Edit Packet Filter Rules
When Enable is selected, the buttons on the Packet Filter List section become active.
Click on the Add button to create a new client in the list. You can create up to the maximum number of concurrent GRE
tunnels that you had set previously in the Packet Filter Rule Configuration section, see above.
244 of 359
© NetComm Wireless 2019
Figure 280 – Enable Packet Filters
Notes
Check Enable to activate the Packet Filter
Checkbox, disabled by
default.
functionality.
Drop down list
When Deny those match the following rules is selected
packets that meet the criteria of the rule will be blocked
Deny those match the
– "black listed"– and any other packets will be allowed
following rules is the
to pass.
default setting.
In contrast, Allow those match the following rules will
allow those packets that meet the criteria of the rule to
pass, that is be part of the "White List", and the rest will
be blocked.
Check Log Alert to activate event logging.
Disabled by default
Button
Click Save to save the setting.
Button
Click Undo to cancel the changes to settings.
Table 169 – Enable Packet Filters
Figure 281 – Packet Filter Rule Configuration
Description
User Guide
Advertisement
Table of Contents
