Sms Configuration For Redirection; Sms Configuration For Remote Diagnostics; New Message - NetComm NTC-6000 SERIES User Manual

9.2

SMS Configuration for Redirection

Incoming text messages can be redirected to another mobile device and/or a TCP/UDP message server.
Redirect To Mobile
You can forward incoming text messages to a different destination number. This destination number can be another mobile phone or 3G
router phone number. To disable the feature, simply delete the number in the 'Redirect To Mobile" field and click the "Save" button.
For Example: If someone sends a text message and Redirect To Mobile is set to "0412345678", this text message is stored on the router
and forwarded to "0412345678" at the same time.
Redirect to TCP & TCP Port, Redirect to UDP & UDP Port
You can also forward incoming text messages to a TCP/UDP based destination. The TCP or UDP server can be any kind of public or
private server if the server accepts incoming text-base message.
The TCP/UDP address can be an IP address or domain name. The port number range is from 1 to 65535. Please refer to your TCP/UDP
based SMS server configuration for which port to use.
For Example: If someone sends a text message and Redirect To TCP is set to "192.168.20.3" and "2002", this text message is stored in
the router and forwarded to "192.168.20.3" on port "2002" at the same time.
9.3

SMS Configuration for Remote Diagnostics

Enable Remote Diagnostics
Enable or disable the Remote Diagnostics feature. If this setting is enabled all incoming text messages are parsed and tested for if they
contain Remote Diagnostics commands.
If Remote Diagnostics commands are found, the router executes those commands. This feature is disabled by default.
Please note: It is possible to adjust settings and prevent your router from functioning correctly. If this occurs, you will need to perform a factory reset in order to restore
normal operation. It is highly recommended to enable security when utilising this feature.
9.4

New Message

Send a new text message to multiple recipients.
A new SMS message can be sent to a maximum of 100 recipients at the same time. After sending the message, the result is displayed
next to the destination number as "Success" (in blue) or "Failure" (in red).
By default 10 recipient entry fields are shown on this page however you can increase or decrease this number by pressing the + or – button
at right side of the last recipient entry field.
You can select to enable or disable individual message recipients by selecting the checkbox beside each entered number.
After entering the appropriate recipient numbers, type your SMS message in the "Message Body" field and then click the "Send" button.
YML6000
www.netcomm.com.au
NetComm CallDirect™ Series - NTC-6000 Series
NTC-6000 User Guide
41