NetComm NTC-400 Series User Manual page 230

Item
Delete Button
Enable Button
Edit Button
Select Checkbox
When Add or Edit button is applied, the L2TP Client Configuration window will appear:
Item
Tunnel Name Mandatory field.
1 - 32 characters
Interface Mandatory field.
Operation Mandatory field.
mode
230 of 359
© NetComm Wireless 2019
Notes
Click  Select for the User Account that you want to permanently delete
and then click the Delete button.
Click the Edit button to select Tunnel  Enable in the L2TP Client
Configuration window.
Note that you can uncheck  Enable rather than permanently Delete, this
will allow you to retain the user details while disabling its access to the
L2TP client.
Click the Edit button to make changes to the client in the L2TP Client
Configuration window.
Click  Select on one or more Client descriptions and then click the Delete
button to permanently remove them from the list..
Table 160 – L2TP Client List & Status
Figure 266 – L2TP Client Configuration
Notes
Add a meaningful name.
WAN-1 is available only when WAN-1 interface is enabled).
The same applies to other WAN interfaces (i.e. WAN-2).
There are three available operation modes: Always on, Failover, Load
Balance
Failover/ Always on: Define whether the PPTP client is a failover tunnel
function or an always on tunnel.
Note – If this PPTP is a failover tunnelling, you will need to select
a primary IPSec tunnel from which to failover to.
Load Balance – Define whether the PPTP tunnel connection will take part
in load balance function of the gateway. You will not need to select which
WAN interface as the system will automatically utilize the available WAN
Description
Description
User Guide