Create / Edit Static Routing Rules - NetComm NTC-400 Series User Manual

Item
Static Routing
3.6.1.3

Create / Edit Static Routing Rules

The Static Routing Rule List shows the setup parameters of all static routing rule entries. To configure a static routing rule,
you must specify related parameters including the destination IP address and subnet mask of the dedicated host/server or
subnet, the IP address of a peer gateway, the metric and the rule activation.
The router allows you to customise your static routing rules. It supports up to a maximum of 64 rule sets. When Add button
is applied, Static Routing Rule Configuration screen will appear, while the Edit button at the end of each static routing rule
can let you modify the rule.
Item
Destination IP
Subnet Mask
Gateway IP
Interface
Metric
Rule
Save
Undo
NTC-400 Series
Notes
Disabled by default. Check the Enable box to activate this function
Table 93 – Enable Static Routing
Figure 163 – Create / Edit Static Routing Rules
Figure 164 – IPv4 Static Routing Rule Configuration
Notes
Mandatory field. Enter Specify the Destination IP of this static routing rule.
in IPv4 format.
255.255.255.0 Specify the Subnet Mask of this static routing rule.
Default setting: (/24)
Mandatory field. Enter Specify the Gateway IP of this static routing rule.
in IPv4 format.
Default setting: Auto Select the Interface of this static routing rule. It can be Auto,
or the available WAN / LAN interfaces.
Mandatory field. The Metric of this static routing rule.
Numeric string format.
Value Range: 0 - 255.
Click  Enable to activate this rule.
Disabled by default.
Button Click the Save button to save the configuration
Button Click the Undo button to restore what you just configured
back to the previous setting.
Description
Description
© NetComm Wireless 2019
135 of 359