Create/Edit Content Filter Rules - NetComm NTC-400 Series User Manual

Item
Log Alert
Save
Undo
6.2.3.3

Create/Edit Content Filter Rules

When  Enable is selected, the buttons on the Content Filter List section become active.
Click on the Add button to create a new rule in the list. You can add up to twenty (20) Content Filter rules.
Item
Rule Name Mandatory field.
String format.
Source IP Mandatory field.
Default setting: Any
252 of 359
© NetComm Wireless 2019
Notes
following keywords: .ocx, .cab, .ole, .olb, .com, .vbs,
.vrm or .viv
When selected if any one of the matching criteria is
found it a packet, it packets will be dropped.
Check Log Alert  Enable to activate event logging
Disabled by default
for the selected rules.
Button Click Save to save the setting.
Button Click Undo to cancel the changes to settings.
Table 173 – Enable Web content Filters
Figure 289 – Web Content Filter List
Table 174 – Web Content Filter List
Notes
Enter a meaningful name of up to 30 characters for the Content Filter
rule.
This field is to specify the Source IP address.
Select Any to filter packets coming from any IP addresses.
Select Specific IP Address to filter packets coming from an IP address
entered in this field.
Select IP Range to filter packets coming from a specified range of IP
address entered in this field.
Select IP Address‐based Group from the drop down list to filter
packets coming from the selected group.
Description
Description
User Guide