NetComm NTC-400 Series User Manual page 23

Item Value setting
WAN interface IPv6 Network Status
The WAN interface IPv6 Network Status screen shows status information for IPv6 network.
Item
ID
Interface
WAN Type
Link-local IP
Address
Global IP
Address
Conn. Status
Action
NTC-400 Series
Connect Manually (Refer to Edit button in Basic Network > WAN & Uplink > Internet
Setup) and WAN connection status is disconnected.
Disconnect button – Allows user to manually disconnect the device from the Internet. Note:
Connect button is available when Connection Control in WAN Type setting is set to
Connect Manually (Refer to Edit button in Basic Network > WAN & Uplink > Internet
Setup) and WAN connection status is connected.
Table 4 – WAN interface IPv4 Network Status
Figure 12 – WAN interface IPv6 Network Status
Value setting
System data. Displays corresponding WAN interface WAN IDs.
System data. Displays the type of WAN physical interface.
Depending on the model purchased, it can be Ethernet, 3G/4G, etc...
System data. Displays the method which public IP address is obtained from your
ISP. WAN type setting can be changed from Basic Network > IPv6 >
Configuration.
System data. Displays the LAN IPv6 Link-Local address.
System data. Displays the IPv6 global IP address assigned by your ISP for your
Internet connection.
System data. Displays the connection status. The status can be connected,
disconnected and connecting.
System data. This area provides functional buttons.
Edit Button when pressed, web-based utility will take you to the IPv6
configuration page. (Basic Network > IPv6 > Configuration.)
Table 5 – WAN interface IPv6 Network Status
Description
Description
23 of 359
© NetComm Wireless 2019