Serirq Control Register 0 (Sirqcr0) - Renesas H8S/2100 Series Hardware Manual

20.3.13 SERIRQ Control Register 0 (SIRQCR0)

SIRQCR0 contains status bits that indicate the SERIRQ operating mode and bits that specify
SERIRQ interrupt sources.
Bit Bit Name Initial Value Slave Host Description
7 Q/C 0
6 SELREQ 0
5 IEDIR2 0
R/W

R Quiet/Continuous Mode Flag
Indicates the mode specified by the host at the end
of an SERIRQ transfer cycle (stop frame).
0: Continuous mode
[Clearing conditions]
•
LPC hardware reset, LPC software reset
•
Specification by SERIRQ transfer cycle stop
frame
1: Quiet mode
[Setting condition]
Specification by SERIRQ transfer cycle stop frame.

R/W Start Frame Initiation Request Select
Selects the condition of a start frame initiation
request when a host interrupt request is cleared in
quiet mode.
0: Start frame initiation is requested when all
interrupt requests are cleared
1: Start frame initiation is requested when one or
more interrupt requests are cleared

R/W Interrupt Enable Direct Mode 2
Selects whether an SERIRQ interrupt generation of
LPC channel 2 is affected only by a host interrupt
enable bit or by an OBF flag in addition to the enable
bit.
0: A host interrupt is generated when both the enable
bit and the corresponding OBF flag are set
1: A host interrupt is generated when the enable bit
is set
Section 20 LPC Interface (LPC)
Rev. 1.00 Apr. 28, 2008 Page 645 of 994
REJ09B0452-0100