For Micro Pc Modules - YASKAWA MOTIONPACK-110 Descriptive Information

10.5 MICRO PC MODULE ADDRESSING (Cont'd)
d
Set the address with a minus screw driver through the square hole of 2SW on the q
micro PC module, as shown in Fig. 10.9.
q
J
jfJ
S _
• 586-270
Fig. 10.9
,,d
10.6 INDICATIONS FOR MICRO PC MODULES q
10.6.1 INDICATIONS OF INPUT SIGNAL MONITOR
These indications are used to check whether the input signals are normally entering into the
input connectors (1CN, 2CN, 5CN) of micro PC module. There are eight indicator lamps,
but the I/O signals on machine side can be checked since the lamps are combined with the
,d
indication changeover switch (1SW). Lamps are lit when the input signals are on and turned I
off when input signals are off. Fig. 10.10 shows the checking method of input signal, and
Table 10.4 gives the list of indications and input signals.
INDICATIONS OF
INPUT SIGNAL
MONITOR
INDICATION
CHANGE-0VER
SWITCH (lSW)
STATUS
INDICATION
586-2_{_
Fig. 10.10 Indications of Micro PC Module
214