YASKAWA MOTIONPACK-110 Descriptive Information page 101

5.3.2 FUNCTION SELECTION (#1001, #1002, #1003i #1005, #1006, #1009)(Cont'd)
#1003 D7 D6 D5 D4 I D3 D2 D1 DO
0 0 0 1 0 1 0
l Is G31 (skip function) programmed, whether to
]
initiate alarm if skip signal is not input ?
Whether there is position memory.
S 5-digit D/A output (fixed to 1).
Whether notch signal is output.
(1) If #1003 DO is set to 1, no alarm is activated; if it is set to 0, an alarm is activated.
(2) If #1003 D1 is set to 1, the position memory is activated.
(3) If #1003 D4 is set to 1, the T function output pins (T, _-T28) are used for notch signal
output. See Par. 4.2.15.
(4) Parameters #1003-D5 and -D6 are set to specify transmission items in the communica-
tion function (DNC). If the communication function is not set, set the bits to 0.
!
#1004 D7 I D6 D5 D4 D3 D2 D1 DO
I
OlO IO IO o
o o
o
#1005 D7 D6 I D5 D4 D3 D2 I D1 DO
I I
A
[ Designation of 1 decimal place
Designation of 2 decimal place
Designation of 3 decimal place
Designation of 4 decimal place
Designation of 2 digits offset value input BCD
Designation of 4 digits offset value input BCD
Designation of 6 digits offset value input BCD
Designation of 8 digits offset value input BCD
(1) If #1005-D0 to -D2 are all set to 0, decimal point representation is not made.
NOTE
Set only one of DO to D2 to 1.
(2) Offset value input from an external source is made by using input signal numbers #4011
to #4014. See Par. 4.2.7.
NOTE
Set only one of D4 to D7 to 1.
88