YASKAWA MOTIONPACK-110 Descriptive Information page 50

(2) End of search
(_) The pointer of the part program memory points to the top of the data found (pointed
by the cursor). In all cases, only search will be performed but neither BUF display
nor advance reading will be performed•
MEMORY POINTER
\ /
t
DATA FOUND
@ "NOT FOUND!" appears on the CRT if the desired data is not found. This message
will disappear when a key ( [] normally)of the control station is depressed.
(3) Remarks
• Do not omit leading zeros of the search data. • The data itself which has been entered
through the keyboard will be compared with those in the part program memory.
When searching a program number, leading zeros may be omitted.
• Commands encountered during search will be disregarded even if they are modal
commands•
• On Cycle Start after search, the data of a block which the cursor points to will be read
• and executed.
3.14 PARAMETER/PROGRAM PROTECT FUNCTION
This function ignores write-in parameter from CRT control station and editing of machining
program.
When protect signal (PRT)is turned ON, _ , _-_ and [] keys are
ineffective in EDIT mode. _] key in parameter display is also ineffective and
writing can not be changed•
NOTE
[] and [_] keys on a personal computer are not affected.
37