SA (Spectrum Analyzer) Mode (Option 233–Mixed Analyzers)FUTURE
SA Mode Settings
A color-coded legend for displayed traces is visible in the left pane of the SA
mode screen:
W = Clear/Write; M = MaxHold; m = MinHold; A = Average; V = View
How to display the Trace States
1. Press Trace 6.
2. Then
3. Then
4. Then choose from the following Trace States:
5. Press
Trace 4 data WILL be overwritten by the FieldFox when using the
Independent Source Normalize feature
Generator " on page
corrections
Average Type
In SA Mode, there are four different processes in which Averaging is performed:
— Average Traces – Learn more in
— Detection Method Averaging – Learn more in
204
Trace 1,2,3,4
repeatedly to select a trace number to display or
change its state. Traces are displayed in the following colors:
— Trace 1 – Yellow
— Trace 3 – Orange
State [current setting]
—
Clr /Wr
(Clear/Write) Displays the actual measured data for each
sweep.
—
MaxHold
Displays the maximum response of the input signal at each
data point over multiple sweeps. See also Average Count in
"Average Count" on page
—
MinHold
Displays the minimum response of the input signal at each
data point over multiple sweeps. See also Average Count in
"Average Count" on page
—
Average
Each data point is averaged over multiple sweeps as set by
the Average Count setting. Learn more in
page
205.
—
View
Displays and then holds the last complete measurement trace
on the screen. This is similar to storing a trace in memory.
—
Blank
Displays no trace.
Default All
to return all traces to their default settings: Trace 1
(Clear/Write); all other traces (Blank).
186) or using Field Strength antenna or cable
("Field Strength Measurements" on page
page
213.
Trace 2 – Blue
Trace 4 – Green
205.
205.
"Average Count" on
("Independent Source/Tracking
"Averaging" on page
"Detection Method" on
Keysight N9915-90020 User's Guide
163).
221.