Performance Tests; Source Power Accuracy Test - Keysight Technologies N5247B Service Manual

Tests and Adjustments

Performance Tests

Performance Tests
The performance tests verify the electrical performance of your PNA. These
performance tests are included in the analyzer's firmware with Option
S93898A. Your analyzer is automatically configured for each individual test.
The model numbers of the equipment used by these performance tests are
specified under
There are nine tests in the Option S93898A performance test package:
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—
—

Source Power Accuracy Test

Function of the Test: To confirm the accuracy of the source output power of
your network analyzer over its full frequency range.
Specification Tested: Test Port Output–Power Level Accuracy
Equipment Used:
— Power meter
— Power sensors
— Any necessary adapters
3-32
"Required Service Test Equipment" on page
Source Power Accuracy Test
Source Maximum Power Output Test
Source Power Linearity Test
Frequency Accuracy Test
Trace Noise Test
Receiver Compression Test
Noise Floor Test
Calibration Coefficients Test
Dynamic Accuracy Test – Version 1
Dynamic Accuracy Test – Version 2
Dynamic Accuracy at Low Frequency (Available with LFE Option
205/220/420/425)
Dynamic Accuracy at Low Frequency (Available with LFE Option
205/220/420/425)
Receiver Noise Figure Test
Noise Jitter Test
Noise Receiver Linearity Test
Noise Receiver Compression Test
2-4.
Keysight N5247B Service Guide