Edge-Core ECS4660-28F Management Manual page 684

Hide thumbs Also See for ECS4660-28F:

Table of Contents

| Multicast Filtering

Multicast VLAN Registration for IPv6

Use the Multicast > MVR6 (Configure Static Group Member) page to

statically bind multicast groups to a port which will receive long-term

multicast streams associated with a stable set of hosts.

"mvr6 vlan group" on page 1505

Multicast groups can be statically assigned to a receiver port using this

configuration page.

All IPv6 addresses must be according to RFC 2373 "IPv6 Addressing

Architecture," using 8 colon-separated 16-bit hexadecimal values. One

double colon may be used in the address to indicate the appropriate

number of zeros required to fill the undefined fields. (Note that the IP

address ff02::X is reserved.)

The MVR6 VLAN cannot be specified as the receiver VLAN for static

These parameters are displayed:

Domain ID – An independent multicast domain. (Range: 1-5)

Interface – Port or trunk identifier.

VLAN – VLAN identifier. (Range: 1-4094)

Group IPv6 Address – Defines a multicast service sent to the selected

port. Multicast groups must be assigned from the MVR6 group range

configured on the Configure General page.

To assign a static MVR6 group to an interface:

Click Multicast, MVR6.

Select Configure Static Group Member from the Step list.

Select Add from the Action list.

Select an MVR6 domain.

Select a VLAN and interface to receive the multicast stream, and then

enter the multicast group address.

Click Apply.

Chapters

Table of Contents