Edge-Core ECS4660-28F Management Manual page 921

◆
E
XAMPLE
Console(config)#upgrade opcode auto
Console(config)#upgrade opcode path tftp://192.168.0.1/sm24/
Console(config)#
If a new image is found at the specified location, the following type of
messages will be displayed during bootup.
. .
.
Automatic Upgrade is looking for a new image
New image detected: current version 1.1.1.0; new version 1.1.1.2
Image upgrade in progress
The switch will restart after upgrade succeeds
Downloading new image
Flash programming started
Flash programming completed
The switch will now restart
. .
.
This command specifies an TFTP server and directory in which the new
upgrade opcode
opcode is stored. Use the no form of this command to clear the current
path
setting.
S
YNTAX
D
EFAULT
None
C
OMMAND
Global Configuration
C
OMMAND
◆
◆
Any changes made to the default setting can be displayed with the
show running-config or
upgrade opcode path opcode-dir-url
no upgrade opcode path
opcode-dir-url - The location of the new code.
S
ETTING
M
ODE
U
SAGE
This command is used in conjunction with the
command to facilitate automatic upgrade of new operational code
stored at the location indicated by this command.
The name for the new image stored on the TFTP server must be
ecs4660-28f.bix. However, note that file name is not to be included in
this command.
– 921 –
| System Management Commands
C 24
HAPTER
Automatic Code Upgrade Commands
show startup-config commands.
upgrade opcode auto