Table of Contents
Advertisement
W
EB
To configure an IPv6 address:
1.
2.
3.
4.
Figure 408: Configuring an IPv6 Address
Use the IP > IPv6 Configuration (Show IPv6 Address) page to display the
S
HOWING
IPv6 addresses assigned to an interface.
IP
6 A
V
DDRESSES
CLI R
◆
P
ARAMETERS
These parameters are displayed:
◆
◆
◆
I
NTERFACE
Click IP, IPv6 Configuration.
Select Add IPv6 Address from the Action list.
Specify the VLAN to configure, select the address type, and then enter
an IPv6 address and prefix length.
Click Apply.
EFERENCES
"show ipv6 interface" on page 1672
VLAN – ID of a configured VLAN. By default, all ports on the switch are
members of VLAN 1. However, the management station can be
attached to a port belonging to any VLAN, as long as that VLAN has
been assigned an IP address. (Range: 1-4094)
IPv6 Address Type – The address type (Global, EUI-64, Link Local).
IPv6 Address – An IPv6 address assigned to this interface.
In addition to the unicast addresses assigned to an interface, a node is
also required to listen to the all-nodes multicast addresses FF01::1
(interface-local scope) and FF02::1 (link-local scope).
FF01::1/16 is the transient interface-local multicast address for all
attached IPv6 nodes, and FF02::1/16 is the link-local multicast address
for all attached IPv6 nodes. The interface-local multicast address is
only used for loopback transmission of multicast traffic. Link-local
multicast addresses cover the same types as used by link-local unicast
addresses, including all nodes (FF02::1), all routers (FF02::2), and
solicited nodes (FF02::1:FFXX:XXXX) as described below.
– 703 –
C
16
HAPTER
Setting the Switch's IP Address (IP Version 6)
| IP Configuration
Advertisement
Chapters
Table of Contents
