Edge-Core ECS4660-28F Management Manual page 736

| IP Services
C 17
HAPTER
Configuring the PPPoE Intermediate Agent
C
ONFIGURING
PPP E IA
O
I S
NTERFACE ETTINGS
Operational Generic Error Message – The configured generic error
◆
message.
W I
EB NTERFACE
To configure global settings for PPPoE IA:
Click IP Service, PPPoE Intermediate Agent.
1.
Select Configure Global from the Step list.
2.
Enable the PPPoE IA on the switch, set the access node identifier, and
3.
set the generic error message.
Click Apply.
4.
Figure 439: Configuring Global Settings for PPPoE Intermediate Agent
Use the IP Service > PPPoE Intermediate Agent (Configure Interface) page
to enable PPPoE IA on an interface, set trust status, enable vendor tag
stripping, and set the circuit ID and remote ID.
CLI R
EFERENCES
"PPPoE Intermediate Agent" on page 1081
◆
P
ARAMETERS
These parameters are displayed:
◆ Interface – Port or trunk selection.
PPPoE IA Status – Enables the PPPoE IA on an interface.
◆
(Default: Disabled)
Note that PPPoE IA must also be enabled globally on the switch for this
command to take effect.
Trust Status – Sets an interface to trusted mode to indicate that it is
◆
connected to a PPPoE server. (Default: Disabled)
Set any interfaces connecting the switch to a PPPoE Server as
■
trusted. Interfaces that connect the switch to users (PPPoE clients)
should be set as untrusted.
– 736 –