Edge-Core ECS4660-28F Management Manual page 859

Hide thumbs Also See for ECS4660-28F:

Table of Contents

To configure the switch as a BSR candidate:

Figure 541: Configuring a PIM6-SM BSR Candidate

Use the Routing Protocol > PIM6 > SM (RP Address) page to configure a

static address as the Rendezvous Point (RP) for a particular multicast

length is less than 32, then only the first portion of the hash is used,

and a single RP will be defined for multiple groups. (Range: 0-32;

Default: 10)

Priority – Priority used by the candidate bootstrap router in the

election process. The BSR candidate with the largest priority is

preferred. If the priority values are the same, the candidate with the

larger IP address is elected to be the BSR. Setting the priority to zero

means that this router is not eligible to server as the BSR. At least one

router in the PIM6-SM domain must be set to a value greater than zero.

(Range: 0-255; Default: 0)

Click Routing Protocol, PIM6, PIM6-SM.

Select BSR Candidate from the Step list.

Specify the VLAN interface for which this router is bidding to become

the BSR, the hash mask length that will subsequently be used for RP

selection if this router is selected as the BSR, and the priority for BSR

Click Apply.

"ipv6 pim rp-address" on page 1964

The router will act as an RP for all multicast groups in the local PIM6-SM

domain if no groups are specified. A static RP can either be configured

for the whole multicast group range FF00::/8, or for specific group

| Multicast Routing

Configuring PIMv6 for IPv6

Chapters

Table of Contents