Table of Contents
Advertisement
To show the summary addresses for external routes:
1.
2.
3.
Figure 506: Showing Summary Addresses for External Routes
You should specify a routing interface for any local subnet that needs to
C
ONFIGURING
communicate with other network segments located on this router or
OSPF I
NTERFACES
elsewhere in the network. First configure a VLAN for each subnet that will
be directly connected to this router, assign IP interfaces to each VLAN (i.e.,
one primary interface and one or more secondary interfaces), and then use
the Network Area configuration page to assign an interface address range
to an OSPF area.
After assigning a routing interface to an OSPF area, use the Routing
Protocol > OSPF > Interface (Configure by VLAN) or (Configure by
Address) page to configure the interface-specific parameters used by OSPF
to set the cost used to select preferred paths, select the designated router,
control the timing of link state advertisements, and specify the method
used to authenticate routing messages.
CLI R
◆
C
OMMAND
◆
◆
P
ARAMETERS
These parameters are displayed:
◆
Configuring the Open Shortest Path First Protocol (Version 2)
Click Routing Protocol, OSPF, Summary Address.
Select Show from the Action list.
Select the process ID.
EFERENCES
"Open Shortest Path First (OSPFv2)" on page 1750
U
SAGE
The Configure by VLAN page is used to set the OSPF interface settings
for the all areas assigned to a VLAN on the Network Area (Add) page
(see
page
790).
The Configure by Address page is used to set the OSPF interface
settings for a specific area assigned to a VLAN on the Network Area
(Add) page (see
page
790).
VLAN ID – A VLAN to which an IP interface has been assigned.
– 811 –
| Unicast Routing
C
20
HAPTER
Advertisement
Chapters
Table of Contents
