Edge-Core ECS4660-28F Management Manual page 856

| Multicast Routing
C 21
HAPTER
Configuring PIMv6 for IPv6
D
ISPLAYING
PIM6 N
EIGHBOR
I
NFORMATION
C G
ONFIGURING LOBAL
PIM6-SM S
ETTINGS
Use the Routing Protocol > PIM6 > Neighbor page to display all
neighboring PIMv6 routers.
CLI R
EFERENCES
"show ipv6 pim neighbor" on page 1958
◆
P
ARAMETERS
These parameters are displayed:
◆ Address – IP address of the next-hop router.
VLAN – VLAN that is attached to this neighbor.
◆
Uptime – The duration this entry has been active.
◆
Expire – The time before this entry will be removed.
◆
◆ DR – The designated PIM6-SM router. If multicast hosts are directly
connected to the LAN, then only one of these routers is elected as the
DR, and acts on behalf of these hosts, sending periodic Join/Prune
messages toward a group-specific RP for each group.
W I
EB NTERFACE
To display neighboring PIMv6 routers:
Click Routing Protocol, PIM6, Neighbor.
1.
Figure 539: Showing PIMv6 Neighbors
Use the Routing Protocol > PIM6 > SM (Configure Global) page to
configure the rate at which register messages are sent, the source of
register messages, and switchover to the Shortest Path Tree (SPT).
CLI R
EFERENCES
"IPv6 PIM Commands" on page 1950
◆
P
ARAMETERS
These parameters are displayed:
Register Rate Limit – Configures the rate at which register messages
◆
are sent by the Designated Router (DR) for each (source, group) entry.
(Range: 1-65535 packets per second: Default: disabled)
This parameter can be used to relieve the load on the designated router
(DR) and rendezvous point (RP). However, because register messages
– 856 –