Table 109: Ipv6 Acl Commands - Edge-Core ECS4110-28T Management Manual

| Access Control Lists
C 26
HAPTER
IPv6 ACLs
show ip access-list
IP 6 ACL
V S
R C
ELATED OMMANDS
ip access-group (975)
This command displays the rules for configured IPv4 ACLs.
S
YNTAX
show ip access-list {standard | extended} [acl-name]
standard – Specifies a standard IP ACL.
extended – Specifies an extended IP ACL.
acl-name – Name of the ACL. (Maximum length: 32 characters)
C M
OMMAND ODE
Privileged Exec
E
XAMPLE
Console#show ip access-list standard
IP standard access-list david:
permit host 10.1.1.21
permit 168.92.0.0 255.255.15.0
Console#
R C
ELATED OMMANDS
permit, deny (971)
ip access-group (975)
The commands in this section configure ACLs based on IPv6 addresses,
DSCP traffic class, or next header type. To configure IPv6 ACLs, first create
an access list containing the required permit or deny rules, and then bind
the access list to one or more ports.

Table 109: IPv6 ACL Commands

Command Function
access-list ipv6 Creates an IPv6 ACL and enters configuration mode for
standard or extended IPv6 ACLs
permit, deny Filters packets matching a specified source IPv6
address
permit, deny Filters packets meeting the specified criteria, including
source or destination IPv6 address, DSCP traffic class,
or next header type
ipv6 access-group Adds a port to an IPv6 ACL
show ipv6 access-group Shows port assignments for IPv6 ACLs
show ipv6 access-list Displays the rules for configured IPv6 ACLs
– 976 –
Mode
GC
IPv6-
STD-ACL
IPv6-
EXT-ACL
IC
PE
PE