Edge-Core ECS4660-28F Management Manual page 776

| Unicast Routing
C 20
HAPTER
Configuring the Routing Information Protocol
P
ARAMETERS
These parameters are displayed:
By Address – Adds a network to the RIP routing process.
◆
Subnet Address – IP address of a network directly connected to
■
this router. (Default: No networks are specified)
Prefix Length – A decimal value indicating how many contiguous
■
bits (from the left) of the address comprise the network portion of
the address. This mask identifies the network address bits used for
the associated routing entries.
By VLAN – Adds a Layer 3 VLAN to the RIP routing process. The VLAN
◆
must be configured with an IP address. (Range: 1-4094)
W I
EB NTERFACE
To add a network interface to RIP:
Click Routing Protocol, RIP, Network.
1.
Select Add from the Action list.
2.
Add an interface that will participate in RIP.
3.
Click Apply.
4.
Figure 469: Adding Network Interfaces to RIP
To show the network interfaces using RIP:
Click Routing Protocol, RIP, Network.
1.
Select Show from the Action list.
2.
Click IP Address or VLAN.
3.
– 776 –