Edge-Core ECS4660-28F Management Manual page 731

◆
Use the IP Service > UDP Helper > General page to enable the UDP helper
E
NABLING THE
globally on the switch.
UDP H
ELPER
CLI R
◆
P
These parameters are displayed:
◆
W
To enable the UDP help:
1.
2.
3.
Figure 434: Enabling the UDP Helper
Use the IP Service > UDP Helper > Forwarding page to specify the UDP
S UDP
PECIFYING
destination ports for which broadcast traffic will be forwarded when the
D P
ESTINATION ORTS
UDP helper is enabled.
CLI R
◆
C
◆
to forward broadcast packets for specified UDP application ports to
remote servers located in another network segment.
To configure UDP helper, enable it globally (see
DNS Service Parameters" on page
ports for which broadcast traffic will be forwarded (see
Destination Ports" on page
servers or the subnet where the servers are located (see
The Target Server or Subnet" on page
EFERENCES
"ip helper" on page 1660
ARAMETERS
UDP Helper Status – Enables or disables the UDP helper.
(Default: Disabled)
I
EB NTERFACE
Click IP Service, UDP Helper, General.
Mark the Enabled check box.
Click Apply.
EFERENCES
"ip forward-protocol udp" on page 1659
U
OMMAND SAGE
Up to 100 UDP ports can be specified with this command for forwarding
to one or more remote servers.
– 731 –
C
HAPTER
Forwarding UDP Service Requests
"Configuring General
713), specify the UDP destination
731), and specify the remote application
733).
| IP Services
17
"Specifying UDP
"Specifying