Edge-Core ECS4660-28F Management Manual page 932

| System Management Commands
C 24
HAPTER
Line
disconnect
show line
Using the command without specifying a timeout restores the default
◆
setting.
E
XAMPLE
To set the timeout to two minutes, enter this command:
Console(config-line)#timeout login response 120
Console(config-line)#
This command terminates an SSH, Telnet, or console connection.
S
YNTAX
disconnect session-id
session-id – The session identifier for an SSH, Telnet or console
connection. (Range: 0-8)
C M
OMMAND ODE
Privileged Exec
C U
OMMAND SAGE
Specifying session identifier "0" will disconnect the console connection.
Specifying any other identifiers for an active session will disconnect an SSH
or Telnet connection.
E
XAMPLE
Console#disconnect 1
Console#
R C
ELATED OMMANDS
show ssh (1066)
show users (908)
This command displays the terminal line's parameters.
S
YNTAX
show line [console | vty]
console - Console terminal line.
vty - Virtual terminal for remote console access (i.e., Telnet).
D S
EFAULT ETTING
Shows all lines
C M
OMMAND ODE
Normal Exec, Privileged Exec
– 932 –