Toshiba e-STUDIO 5540C Service Manual page 1285

A
B
C
D
[8]
E
F
G
H
A
B
C
D
[9]
E
F
G
H
A
B
C
D
[0]
E
F
G
H
*1
- Be sure to install the USB storage device to the equipment and check if the device can be used
with this code.
- Be sure to turn OFF the write protection (the function to prevent data from erasure by the accidental
recording or deleting) of the USB storage device before performing the check, otherwise this code
cannot be used.
- It may take some time (2 sec. to 10 sec.) before this check is completed depending on the USB
storage device.
Reverse path cover switch
Stopper opening/closing detection
sensor (front)
Stopper opening/closing detection
sensor (rear)
-
Detecting connection between bridge
unit and drawers
(Refer to table 6)
Reverse section paper transport
detection sensor
Standby side tray paper amount
detection sensor
Feed cover sensor
4th drawer bottom sensor
3rd drawer bottom sensor
2nd drawer bottom sensor
1st drawer bottom sensor
4th drawer tray-up sensor / End fence
home position sensor
3rd drawer/tandem LCF tray-up sensor Upper limit position
2nd drawer tray-up sensor
1st drawer tray-up sensor
-
-
-
Security enabler
Judgement for acceptable USB storage
device (*1)
-
-
-
Cover opened
Stopper opened
Stopper opened
-
OFF (H)
Paper present
No paper
Cover closed
Bottom position
Bottom position
Bottom position
Bottom position
Upper limit position /
Tray initial position
Upper limit position
Upper limit position
-
-
-
Connectable
Acceptable
-
-
-
Cover closed
Stopper closed
Stopper closed
-
ON (L)
No paper
Paper present
Cover opened
Normal
Normal
Normal
Normal
Normal
Normal
Normal
Normal
-
-
-
Not connectable
Not acceptable
-
-
-