Toshiba e-STUDIO 5540C Service Manual page 1290

Fuser motor (normal rotation)
129
ON
Bridge unit transport entrance
130
motor ON
Reverse motor (normal
132
rotation) ON
Reverse motor (reverse
134
rotation) ON
Bridge unit transport exit motor
136 (normal rotation) ON (lower
exit tray direction)
Bridge unit transport exit motor
138 (reverse rotation) ON (upper
exit tray direction)
Exit motor (normal rotation)
140
ON (lower exit tray direction)
Exit motor (reverse rotation)
142
ON (upper exit tray direction)
144 ADU motor-2 ON
146 ADU motor-1 ON
*1
Fully pull out the EPU tray toward you while the transfer belt remains. If it is not fully pulled out,
the drum shaft and the drum flange may scratch each other and thus the flange may be worn
out.
*2
1. Pull the duplexing unit lever and then separate the transfer belt and the 2nd transfer roller.
2. Pull out the EPU (developer unit) tray until it comes to a stop while the transfer belt is left.
* Pull out the EPU tray completely otherwise the transfer belt and the photoconductive
drum may scratch each other.
3. Insert a door-switch jig into the cover interlock switch on the left upper side of the fuser
unit in order not to turn the 24 V power OFF.
Normal
179 Code No.129 function OFF
speed
Normal
180 Code No.130 function OFF
speed
Normal
182 Code No.132 function OFF
speed
Normal
184 Code No.134 function OFF
speed
Normal
186 Code No.136 function OFF
speed
Normal
188 Code No.138 function OFF
speed
Normal
190 Code No.140 function OFF
speed
Normal
192 Code No.142 function OFF
speed
Normal
194 Code No.144 function OFF
speed
Normal
196 Code No.146 function OFF
speed
1
1
1
1
1
1
1
1
1
1