Hole Punch Unit Firmware; Checking The Hole Punch Position - Toshiba e-STUDIO 5540C Service Manual

11.4.5 Hole punch unit firmware (MJ-6102)
Important:
• Be sure to shut down the equipment before installing and removing the download jig.
• Do not shut down the equipment during the update. The data could be damaged and not be
able to be operated properly.
[A] Checking the hole punch position
Follow the procedure below to check the stopping position of the paper transport during the punching
operation before updating the firmware, as the value for the position is defaulted when the firmware is
updated.
(1) Press the [ON/OFF] button on the control panel to shut down the equipment.
(2) Remove the finisher board access cover and change the setting of the DIP-SW1 (SW1) on the
finisher control PC board as shown in the figure below.
(3) Press the [ON/OFF] button while simultaneously holding down the [0] and [8] buttons. The
[LED1] on the finisher control panel starts blinking. Count the number of times it blinks. If the
number of blinks is "6", this indicates that the value for the stopping position is the default. If the
number is other than "6", record it because the value needs to be reset after the firmware is
updated.
(4) Return the DIP-SW1 to the status before checking.
© 2011 - 2015 TOSHIBA TEC CORPORATION All rights reserved
Board access cover
Fig.11-35
11 - 43
ON
1 2 3 4
e-STUDIO5540C/6540C/6550C/5560C/6560C/6570C
FIRMWARE UPDATING
11