Suzuki Baleno Manual page 1947

6G1-16 CRANKING SYSTEM
1. Terminal 'S'
2. Terminal 'M'
3. Lead wire (switch to motor)
PERFORMANCE TEST
CAUTION:
Each test must be performed within 3 – 5 seconds to
avoid coil from burning.
1) Pull-In Test
Connect battery to magnetic switch as shown.
Check that plunger and pinion (over-running clutch) move out-
ward.
If plunger and pinion (over-running clutch) don't move, replace
magnetic switch.
NOTE:
Before testing, disconnect lead wire from terminal 'M'.
2) Hold-In Test
While connected as above with plunger out, disconnect nega-
tive lead from terminal 'M'.
Check that plunger and pinion remain out.
If plunger and pinion return inward, replace magnetic switch.
3) Plunger and Pinion Return Test
Disconnect negative lead from switch body.
Check that plunger and pinion return inward.
If plunger and pinion don't return, replace magnetic switch.
4) No-Load Performance Test
1) Connect battery and ammeter to starter as shown.
2) Check that starter rotates smoothly and steadily with pinion
moving out. Check that ammeter indicates specified current.
Specified current: 90A at 11.5V