Suzuki Baleno Manual page 1916

IGNITION SPARK TEST
1) Place transmission gear shift lever in "Neutral" (Shift selector le-
2) Disconnect injector couplers and ignition coil couplers.
3) Remove spark plugs and check them for condition and type, re-
4) If OK, connect ignition coil couplers to ignition coil assemblies
5) Crank engine and check if all spark plugs spark.
1. Ignition coil assembly
2. High-tension cord
3. Ignition coil coupler
6) After checking, install spark plugs and ignition coil assemblies,
7) Connect injector couplers.
ver to "P" range for A/T model), set parking brake, and block
drive wheels.
WARNING:
Without disconnection of injector coupler, combus-
tible gas may come out from spark plug holes during
this test and may get ignited in engine room.
ferring to SPARK PLUG under ON-VEHICLE SERVICE.
and connect spark plugs to ignition coil assemblies and high-
tension cords. Ground spark plug by making thread part of each
spark plug in contact with cylinder head cover.
If no spark is emitted, inspect the related parts as described un-
der DIAGNOSIS.
referring to SPARK PLUG, HIGH-TENSION CORD and IGNI-
TION COIL ASSEMBLY under ON-VEHICLE SERVICE.
IGNITION SYSTEM (G13/G16 ENGINE) 6F1-7