Subaru Impreza 2003 Service Manual page 1913

C: DISASSEMBLY
1. DIFFERENTIAL CASE ASSEMBLY
1) Remove the right and left snap rings from differ-
ential, and then remove the two axle drive shafts.
NOTE:
During reassembly, reinstall each axle drive shaft
in the same place from which it was removed.
2) Loosen the twelve bolts and remove the hypoid
driven gear.
(C)
(B)
(A) Snap ring
(B) Axle drive shaft
(C) Hypoid driven gear
3) Drive out the straight pin from differential assem-
bly toward hypoid driven gear.
ST 899904100 REMOVER
FRONT DIFFERENTIAL ASSEMBLY
(A)
(B)
MT-00809
ST
MT-00276
5MT-105
MANUAL TRANSMISSION AND DIFFERENTIAL
4) Pull out the pinion shaft, and remove the differ-
ential bevel pinion and gear and washer.
(D)
(A)
(A) Pinion shaft
(B) Bevel pinion
(C) Bevel gear
(D) Washer
5) Remove the roller bearing using ST.
ST 399527700 PULLER SET
ST
2. SIDE RETAINER
1) Remove the O-ring.
(B)
(C)
(C)
(D)
(B)
MT-00277
MT-00278
MT-00279